nederlands
deutsch
english
Maximum Technology
Home English
Products for AMF Pinsetters
Products for Brunswick pinsetters
Control box for string machines
Automatic scoringsystem for bowlinglanes
Motors
Other products
Installation- and user manuals
Distributors
The Maximum Technology Foul Unit

The Maximum Technology Foul Unit is a direct replacement for all AMF and Brunswick foul units.
The Maximum Technology Foul Unit contains built-in overload protection as well as diagnostics for alignment. It will even inform you if a short occurs in the output wiring!
 		 Foulline Unit
   
We have designed another unit that is even better protected against vibrations. The sensor unit is separated from the switch unit and can be located in an area where vibration is not an issue.
Foulline sensorunit
Foulline switchunit
    

The Maximum Technology Control Board for AMF 82-70 5-Board Chassis with APS.

The Maximum Technology Control Board is designed to replace all other boards in the AMF 5-board chassis. The use of today's technologies have made it possible to engineer in extra functions that make your machine more reliable and make searching for hard to find electronic failures very easy.
Single board forr AMF 82-70 5-Board Chassis
   Single board in AMF 82-70 5-Board Chassis

The Maximum Technology Control Board checks the machine automatically during every cycle. Any errors detected are made visible by a code number on a display on the PC board.

The Maximum Technology Control Board has a built-in 'APS' input to communicate with automatic scoring systems. This gives your machine extra functions like 'fast strike cycle' and 'sweep reverse'. This speeds up the game and reduces mechanical wear. With 'APS' input, the table wiring to the gripper switches is no longer needed. This will put an end to all the machine stops caused by respot cell wiring.

The Maximum Technology Control Board has a built-in diagnostics feature. By pressing a button on the board, it can be put into test-mode. In this test-mode you can actuate every switch in the machine. The readout will display the switch actuated and a beeper will sound when the signal reaches the PC board. Troubleshooting could not be simpler!

The Maximum Technology Motor Start Switch
The Maximum Technology Motor Start Switch can be used on all combination or back end motors for 115 or 230 Volt. Sweep reverse function will still work without any modification to the machine wiring. There is no machine wiring necessary so the converted motor can be transferred between machines.
Click on the picture to enlarge   The Maximum Technology Motor Start Switch is mounted on the outside of the motor and is connected with a wiring assembly that plugs into the switch. This replaces the centrifugal switch and points inside the motor making it almost maintenance free!
APS interface for Qubica scoring.

This interface reads the signal from the Qubica camera. It converts the signal to an APS signal that can be read by the Maximum Technology control board and most other chassis and single-boards for the 82-70 machine. The control board can then do a fast strike cycle or do sweep reverse on a gutterball. This speeds up the game and reduces mechanical wear.

The table wiring to the gripper switches is no longer needed. This will put an end to all the machinestops caused by broken respot cell wires or bad inserts!

The APS interface can be used on all Qubica systems with a T-Vision camera.
 
The Maximumum Technology Offspot Switch.
The Maximumum Technology Offspot Switch automatically performs a sweep reverse and advances the machine to 2nd ball. No human interference, no delays! These animations show the difference.

Manual reset after offspot.

 

Automatic reset after offspot.

   

Maximum Technology Offspot switch mounted in the Back End controlbox of the 82-70 machine.